Avaya 4600 Series Installation Manual page 59

8. To change the status, press *.
Depending on the current value, the next sequential valid NVL2Q value is selected and
displayed as the status. For example, if the current value is On (1), pressing * changes the
value to 2 (Off). If the current value is Off (2), pressing * changes the value to 0 (auto).
The display is updated to show the current status of 802.1Q.
9. Press the # button to continue the procedure.
The following text displays left-justified at the top of the display:
VLAN ID=dddd
New=_
where dddd is the value of the 802.1 VLAN ID.
10. Enter a valid value between 0 and 4094 for the new value of the 802.1 VLAN ID.
The following message displays:
VLAN test=ddd
New=_
where ddd is the value of the DHCPOFFER wait period.
11. Enter a valid value between 0 and 999 for the new value of the DHCPOFFER wait period.
The following message displays:
Save new
values?
*=no #=yes
12. Press the # button to save the new values you entered.
The following message displays:
New values
being saved
Once the new values are stored if the value of PROCSTAT is "1" the telephone is reset. If
PROCSTAT is not "1" all IP telephones with a display clear the display and prompt "Enter
command" to allow entry of the access code to another local administrative procedure.
If a new boot program is downloaded from the TFTP server after you enter static addressing
information, you must reenter your static addressing information.
Static Addressing Installation
Issue 7 July 2008 59