Pre-Installation Checklist For Static Addressing - Avaya 4600 Series Installation Manual

Hide thumbs Also See for 4600 Series:

Installation manual (344 pages)

Administrator's manual (256 pages)

Connecting (14 pages)

Table Of Contents

100

101

102

103

104

105

106

107

108

109

110

Table of Contents

"Supplicant mode" (software Release 2.9 and up) or "No pass-thru" (for earlier releases)

●

if DOT1X = 2

3. To change the setting, press *.

Depending on the current value, the next sequential valid mode value is selected and

displayed as the setting. For example, if the current value is Pass-thru (0), pressing *

changes the value to 1 (Pass-thru with Logoff). If the current value is Supplicant mode (2),

pressing * changes the value to 0 (Pass-thru).

4. When the 802.1X setting is correct, press # (OK). All telephones display the following text:

Supplicant=setting

*=change #=OK

where setting corresponds to the current value of the system value DOTIXSTAT (802.1X

Supplicant Mode operation control), defined as:

"Disabled" if DOT1XSTAT = 0

●

"Unicast-only" if DOT1XSTAT = 1

●

"Unicast/multicast" if DOT1X = 2

●

5. To change the setting, press *.

Depending on the current value, the next sequential valid mode value is selected and

displayed as the setting. For example, if the current value is Disabled (0), pressing *

changes the value to 1 (Unicast-only). If the current value is Unicast/multicast (2), pressing

* changes the value to 0 (Disabled).

6. When the Supplicant setting is correct, press #.

All telephones except the 4601 display the following text left-justified at the top of the

display:

Save new value?

*=no

7. Press the * button to terminate the procedure, or the # button to save the new value. If you

press the # button, all telephones except the 4601 display the following text:

New value being saved

The telephone saves the new value.