Avaya 4600 Series Installation Manual page 102

Restart Scenarios
3. While either the application file if there is one or the boot code is uncompressed into RAM,
the following message displays:
Loading: 5 secs
4620_031225.app
This message counts the seconds as the application file (4620_031225.app in this
example) is being written into RAM.
4. When control is passed to the code in RAM, the following message displays:
Starting...
5. The telephone detects and displays the speed of the Ethernet interface in Mbps, that is, 0,
10, or 100. The message No Ethernet displays until the software determines whether the
interface is 10 Mbps or 100 Mbps.
Note:
The Ethernet speed indicated is the LAN interface speed for both the telephone
Note:
and any attached PC.
6. The software determines whether sufficient IP Address information was downloaded. In this
scenario, it is discovered that sufficient information has not been downloaded. The
following message displays while the DHCP process is invoked:
DHCP: 0 secs
* to program
Note:
The number of elapsed seconds is incremented once per second, until DHCP
Note:
successfully completes.and any attached PC.
!
Important:
If necessary, invoke the local administrative ADDR procedure for static
Important:
addressing by pressing * at any time while the prompt * to program displays.
However, PROCSTAT must be zero and PROCPSWD must be null to invoke the
ADDR local procedure.
7. The following message displays while the TFTP or HTTP process is invoked:
TFTP: n
www.xxx.yyy.zzz
The number increments once per second, until the TFTP or HTTP server responds.
102 4600 Series IP Telephone Installation Guide
4035 KB
HTTP: n uri