Notes And Restrictions On The Use Of The Copy Feature; Notes And Restrictions On The Use Of The Print Feature - Fuji Xerox DocuCentre S2010 User Manual

Notes and Restrictions on the Use of the Copy Feature

Copy Feature
The machine does not offer the Improves Fit function.
ID Card Copy
The front and back side of the placed ID card are printed on each half sheet of a paper
in center except the following cases:
When the size of the ID card is larger than the standard printable size of the ID Card
Copy feature, the image is not printed in center.
When the size of ID card is larger than the standard printable size of the ID Card
Copy feature, a part of the image may be cut off.
The edges of the ID card may be cut off due to the edge erase.
About Memory
If the machine's memory capacity becomes insufficient when copying using the collate
feature, it outputs only the document data which is being scanned.

Notes and Restrictions on the Use of the Print Feature

Output of Long Feed Documents
The output of long feed documents is not supported.
Print Jobs while the Control Panel is being Operated
The print job processing or output speed may be reduced in the following cases:
When the control panel is operated during print job execution
When the Print Results Differ from the Settings
As in the following cases, insufficient memory for the print page buffer may cause print
result in not printing as specified.
A 2 Sided print job is printed on one side.
A job was terminated (If data cannot be written to the print page buffer, the job
including that page is terminated).
Job Counter Counts for 2 Sided Printing
When printing a 2 Sided print job, depending on the application being used, blank
sheets can be inserted automatically to adjust pages. These blank sheets inserted by
the application also are counted by the job counter.
2 Sided Printing
When performing 2 Sided printing with the machine that the Duplex Output Unit is not
installed, it prints only one side.
In this case, the orientation of prints may not be the same as expected.
Error Codes
The error "E-1" occurs besides a paper jam when the paper size setting is not correctly
specified. Refer to the Error Code "C-7" and check paper size setting.
Refer to "Error Code" (P.172).
Notes and Restrictions
195
12