Xerox ColorQube 8700 System Administrator Manual page 85

10. Type a 24-character ASCII key, or 48-character Hexadecimal key for the following:

Encryption Key: IN

Encryption Key: OUT
11. Click Save to apply the new settings or Undo to retain the previous settings.
Configuring Internet Key Exchange Settings
IKE is a keying protocol that allows automatic negotiation and authentication, anti-replay services, and
CA support. It can also change encryption keys during an IPsec session. IKE is used as part of virtual
private networking.
IKE Phase 1 authenticates the IPsec peers and sets up a secure channel between the peers to enable IKE
exchanges. IKE Phase 2 negotiates IPsec SAs to set up the IPsec tunnel.
1. Under IKE Phase 1, in the Key Lifetime field, type the length of time until the key expires in Seconds,
Minutes, or Hours. When a key reaches this lifetime, the SA is renegotiated and the key is
regenerated or refreshed.
2. Select the DH Group from the following options:

Group 2 provides a 1024-bit Modular Exponential (MODP) keying strength.

Group 14 provides a 2048-bit MODP keying strength.
3. Under IKE Phase 2, select the IPsec Mode. Options are Transport Mode or Tunnel Mode.
Note: Transport mode only encrypts the IP payload, whereas Tunnel mode encrypts the IP header
and the IP payload. Tunnel mode provides protection for an entire IP packet by treating it as an
Authentication Header (AH), or Encapsulating Security Payload (ESP).
4. If you selected Tunnel Mode, under Enable Security End Point Address, select the address type.
Options are Disabled, IPv4 Address, or IPv6 Address.
5. Under IPsec Security, select ESP, AH, or BOTH.
6. Type the Key Lifetime, and select Seconds, Minutes, or Hours.
7. Under Perfect Forward Secrecy (PFS), select None, Group 2, or Group 14.
Note: PFS is disabled by default. PFS allows faster IPsec setup, but is less secure.
8. Under Hash, select from the following:

SHA1

None
9. If you selected ESP or BOTH for the IPsec Security type, select one or more of the following
Encryption types:
Note: If the IPsec Security type is set to AH, the Encryption type options do not appear.

AES

3DES

Null
10. Click Save to apply the new settings or Undo to retain the previous settings.
ColorQube 8700/8900 Color Multifunction Printer
System Administrator Guide
Security
85