Xerox ColorQube 8700 System Administrator Manual page 30

Network Configuration
3. To send a release request to the DHCP and DNS servers, under Remove this Device's IPv4 DHCP
Lease and DNS Registration at power down, select Enabled. If the servers grant the request, the
current IP address and any dynamic DNS name are released when the printer is turned off.
4. Under Zero-Configuration Networking, under Self Assigned Address, select Enabled. The Self
Assigned Address option instructs the printer to assign itself an address if a DHCP server does not
provide one.
5. Click Apply to save the new settings or Undo to retain the previous settings.
6. Click Default All to reset settings to default values. This option also disables FIPS 140 mode.
Configuring Settings for IPv6
IPv6 hosts can automatically configure themselves when connected to a routed IPv6 network using the
Internet Control Message Protocol Version 6 (ICMPv6). ICMPv6 performs error reporting for IP along with
other diagnostic functions. When first connected to a network, a host sends a link-local multicast router
solicitation request for configuration parameters. If suitably configured, routers respond to this request
with a router advertisement packet containing network-layer configuration parameters.
1. In CentreWare Internet Services, click Properties > Connectivity > Protocols.
2. Click IP > IPv6.
3. Under Protocol, select Enabled to enable the protocol.
CAUTION: If both IPv4 and IPv6 are disabled, you cannot access CentreWare Internet Services. To
access IPv4 and IPv6 settings in CentreWare Internet Services, enable TCP/IP at the printer control
panel. If you disable TCP/IP or change the IP address, any dependent protocols are disabled and the
network controller restarts.
To allow the router to assign address prefixes, under Stateless Addresses, enable Use Router Supplied
Prefixes.
4. Under Default Dynamic Host Configuration Protocol (DHCP) Settings, select how DHCP operates for
IPv6. Options are:

Use DHCP as directed by a router

Always enable DHCP for address assignment and other configuration data

Always enable DHCP for other configuration data only

Never use DHCP
5. To release the current DCHP-assigned address and any DNS name when the printer is turned off,
select Remove this Device's IPv6 DHCP Lease and DNS Registration at power down.
To specify an address manually, select Enable Manual Address. Select a Router Prefix from the
6.
menu, or type a new router prefix and click Add.
To use an IPv6 address before using an IPv4 address, select Prefer IPv6 Address over IPv4.
7.
8. Click Apply to save the new settings or Undo to retain the previous settings.
Click Default All to reset settings to default values.
9.
30 ColorQube 8700/8900 Color Multifunction Printer
System Administrator Guide