Table of Contents
Advertisement
To set the device back to the factory default settings, press the RESET button for ten seconds or
2
until the PWR/SYS LED begins to blink and then release it. When the PWR/SYS LED begins to
blink, the defaults have been restored and the device restarts.
1.7 Wireless Access
The VMG is a wireless Access Point (AP) for wireless clients, such as notebook computers or PDAs
and iPads. It allows them to connect to the Internet without having to rely on inconvenient Ethernet
cables.
You can configure your wireless network in either the built-in Web Configurator, or using the WPS
button.
Figure 5 Wireless Access Example
1.7.1 Using the Wi-Fi and WPS Buttons
If the wireless network is turned off, press the WLAN button for one second. Once the WLAN/
WPS LED turns green, the wireless network is active.
You can also use the WPS button to quickly set up a secure wireless connection between the VMG
and a WPS-compatible client by adding one device at a time.
To activate WPS:
Make sure the PWR/SYS LED is on and not blinking.
1
Press the WPS button for two seconds and release it.
2
Press the WPS button on another WPS-enabled device within range of the VMG. The WLAN/WPS
3
LED flashes orange while the VMG sets up a WPS connection with the other wireless device.
Once the connection is successfully made, the WLAN/WPS LED shines green.
4
To turn off the wireless network, press the WLAN button for one to five seconds. The WLAN/WPS
LED turns off when the wireless network is off.
Chapter 1 Introducing the VMG
VMG1312-Bx0D User's Guide
21
Advertisement
Table of Contents
