Table of Contents
Advertisement
Figure 109 Access Control: Add/Edit
The following table describes the labels in this screen.
Table 81 Access Control: Add/Edit
LABEL
DESCRIPTION
Filter Name
Enter a descriptive name of up to 16 alphanumeric characters, not including spaces,
underscores, and dashes.
You must enter the filter name to add an ACL rule. This field is read-only if you are editing
the ACL rule.
Order
Select the order of the ACL rule.
Select Source
Select the source device to which the ACL rule applies. If you select Specific IP Address,
Device
enter the source IP address in the field below.
Source IP
Enter the source IP address.
Address
Select
Select the destination device to which the ACL rule applies. If you select Specific IP
Destination
Address, enter the destiniation IP address in the field below.
Device
Destination IP
Enter the destination IP address.
Address
IP Type
Select whether your IP type is IPv4 or IPv6.
Select Protocol
Select the transport layer protocol that defines your customized port from the drop-down
list box. The specific protocol rule sets you add in the Security > Firewall > Service >
Add screen display in this list.
If you want to configure a customized protocol, select Specific Service.
Chapter 16 Firewall
VMG1312-Bx0D User's Guide
194
Advertisement
Table of Contents
