Table of Contents
Advertisement
The following table describes the labels in this screen.
Table 8 Network Setting > Broadband > Add New WAN Interface/Edit (Routing Mode)
LABEL
DESCRIPTION
General
Active
Select this to enable the interface.
Name
Specify a descriptive name for this connection.
Type
Select whether it is an ADSL/VDSL over PTM or ADSL over ATM connection.
Mode
Select Routing if your ISP give you one IP address only and you want multiple computers to
share an Internet account.
Encapsulation
Select the method of encapsulation used by your ISP from the drop-down list box. This
option is available only when you select Routing in the Mode field.
The choices depend on the connection type you selected. If your connection type is ADSL/
VDSL over PTM, the choices are PPPoE and IPoE. If your connection type is ADSL over
ATM, the choices are PPPoE, PPPoA, IPoE and IPoA.
IPv6/IPv4 Mode Select IPv4 Only if you want the VMG to run IPv4 only.
Select IPv6 IPv4 DualStack to allow the VMG to run IPv4 and IPv6 at the same time.
Select IPv6 Only if you want the VMG to run IPv6 only.
PPP Information (This is available only when you select PPPoE or PPPoA in the Mode field.)
PPP User Name
Enter the user name exactly as your ISP assigned. If assigned a name in the form
user@domain where domain identifies a service name, then enter both components exactly
as given.
PPP Password
Enter the password associated with the user name above. Select password unmask to
show your entered password in plain text.
PPP Connection
Select when to have the VMG establish the PPP connection.
Trigger
Auto Connect - select this to not let the connection time out.
On Demand - select this to automatically bring up the connection when the VMG receives
packets destined for the Internet.
Idle Timeout
This value specifies the time in minutes that elapses before the router automatically
disconnects from the PPPoE server.
This field is not configurable if you select Auto Connect in the PPP Trigger Type field.
PPPoE
This field is available when you select PPPoE encapsulation.
Passthrough
In addition to the VMG's built-in PPPoE client, you can enable PPPoE pass through to allow up
to ten hosts on the LAN to use PPPoE client software on their computers to connect to the
ISP via the VMG. Each host can have a separate account and a public WAN IP address.
PPPoE pass through is an alternative to NAT for application where NAT is not appropriate.
Disable PPPoE pass through if you do not need to allow hosts on the LAN to use PPPoE client
software on their computers to connect to the ISP.
IP Address (This is available only when you select IPv4 Only or IPv6 IPv4 DualStack in the IPv6/IPv4
Mode field.)
Obtain an IP
A static IP address is a fixed IP that your ISP gives you. A dynamic IP address is not fixed;
Address
the ISP assigns you a different one each time you connect to the Internet. Select this if you
Automatically
have a dynamic IP address.
Static IP
Select this option If the ISP assigned a fixed IP address.
Address
IP Address
Enter the static IP address provided by your ISP.
Subnet
Enter the subnet mask provided by your ISP.
Mask
Chapter 6 Broadband
VMG1312-Bx0D User's Guide
67
Advertisement
Table of Contents
