Wireless Access - ZyXEL Communications VMG1312-B10C User Manual

Make sure the POWER LED is on (not blinking).
1
To set the device back to the factory default settings, press the RESET button for ten seconds or
2
until the POWER LED begins to blink and then release it. When the POWER LED begins to blink,
the defaults have been restored and the device restarts.

1.7 Wireless Access

The Device is a wireless Access Point (AP) for wireless clients, such as notebook computers or
tablets. It allows them to connect to the Internet without having to rely on inconvenient Ethernet
cables.
You can configure your wireless network in either the built-in Web Configurator, or using the WPS
button.
Figure 4 Wireless Access Example
1.7.1 Using the WLAN/WPS Button
If the wireless network is turned off, press the WLAN/WPS button at the back of the Device for
one second. Once the WLAN/WPS LED turns green, the wireless network is active.
You can also use the WLAN/WPS button to quickly set up a secure wireless connection between
the Device and a WPS-compatible client by adding one device at a time.
To activate WPS:
Make sure the POWER LED is on and not blinking.
1
Press the WLAN/WPS button for five seconds and release it.
2
Press the WPS button on another WPS-enabled device within range of the Device. The WLAN/WPS
3
LED flashes orange while the Device sets up a WPS connection with the other wireless device.
Once the connection is successfully made, the WLAN/WPS LED shines green.
4
To turn off the wireless network, press the WLAN/WPS button on the front of the Device for one
second. The WLAN/WPS LED turns off when the wireless network is off.
VMG1312-B10C User's Guide
Chapter 1 Introducing the Device
21