Table of Contents
Advertisement
10.1 Overview
Quality of Service (QoS) refers to both a network's ability to deliver data with minimum delay, and
the networking methods used to control the use of bandwidth. Without QoS, all traffic data is
equally likely to be dropped when the network is congested. This can cause a reduction in network
performance and make the network inadequate for time-critical application such as video-on-
demand.
Configure QoS on the VMG to group and prioritize application traffic and fine-tune network
performance. Setting up QoS involves these steps:
Configure classifiers to sort traffic into different flows.
1
Assign priority and define actions to be performed for a classified traffic flow.
2
The VMG assigns each packet a priority and then queues the packet accordingly. Packets assigned a
high priority are processed more quickly than those with low priority if there is congestion, allowing
time-sensitive applications to flow more smoothly. Time-sensitive applications include both those
that require a low level of latency (delay) and a low level of jitter (variations in delay) such as Voice
over IP (VoIP) or Internet gaming, and those for which jitter alone is a problem such as Internet
radio or streaming video.
This chapter contains information about configuring QoS and editing classifiers.
10.1.1 What You Can Do in this Chapter
• The General screen lets you enable or disable QoS and set the upstream bandwidth
10.3 on page
• The Queue Setup screen lets you configure QoS queue assignment
• The Classification Setup screen lets you add, edit or delete QoS classifiers
page
144).
• The Shaper Setup screen limits outgoing traffic transmission rate on the selected interface
(Section 10.6 on page
Quality of Service (QoS)
141).
149).
VMG1312-Bx0D User's Guide
139
C
HAPTER
1 0
(Section
(Section 10.4 on page
142).
(Section 10.5 on
Advertisement
Table of Contents
