Table of Contents
Advertisement
Note: The actual data rate you obtain varies depending the 3G card you use, the signal
strength to the service provider's base station, and so on.
Figure 25 Network Setting > Broadband > 3G Backup
The following table describes the labels in this screen.
Table 11 Network Setting > Broadband > 3G Backup
LABEL
DESCRIPTION
General
3G Backup
Select Enable to have the VMG use the 3G connection as your WAN or a backup when the
wired WAN connection fails.
Ping Check
Select Enable if you want the VMG to ping check the connection status of your WAN. You
can configure the frequency of the ping check and number of consecutive failures before
triggering 3G backup.
Check Cycle
Enter the frequency of the ping check in this field.
Consecutive
Enter how many consecutive failures are required before 3G backup is triggered.
Fail
Ping Default
Select this to have the VMG ping the WAN interface's default gateway IP address.
Gateway
Ping the Host
Select this to have the VMG ping the particular host name or IP address you typed in this
field.
3G Connection Settings
Card
This field displays the manufacturer and model name of your 3G card if you inserted one in
description
the VMG. Otherwise, it displays N/A.
Username
Type the user name (of up to 64 ASCII printable characters) given to you by your service
provider.
Password
Type the password (of up to 64 ASCII printable characters) associated with the user name
above.
Chapter 6 Broadband
VMG1312-Bx0D User's Guide
74
Advertisement
Table of Contents
