Denon AVR-2313CI Owner's Manual page 136

Setting items
Add New Feature Upgrade Package : Display the items to be upgraded.
Display new features that Upgrade Status : Display a list of the additional functions provided by
can be downloaded to the upgrade.
this unit and perform an Upgrade start : Execute the upgrade process.
upgrade. When the upgrade starts, the power indicator becomes red and the menu
screen is shut down. During the upgrade, the amount of upgrade time
NOTE
which has elapsed is displayed.
In cases where it is not
When upgrading is complete, the power indicator becomes green and
possible to connect to the normal status is resumed.
network after adding a • If the upgrade is not successful, an error message identical to those in
new function, connect to
"Update" will appear on the display. Check the settings and network
the network again using
environment and then perform the upgrade again.
"Network" (vpage 124).
See the DENON website for details about upgrades.
When the procedure is complete, "Registered" is displayed in this
menu and upgrades can be carried out. If the procedure has not been
carried out, "Not Registered" is displayed.
The ID number shown on this screen is needed when carrying out
the procedure.
The ID number can also be displayed by pressing and holding the main
TUNER PRESET CH –
unit's
Notes concerning use of "Update" and "Add New Feature"
• In order to use these functions, you must have the correct system requirements and settings for a
broadband Internet connection (vpage 23).
• Do not turn off the power until updating or upgrading is completed.
• Even with a broadband connection to the Internet, approximately 1 hour is required for the updating/
upgrading procedure to be completed.
• Once updating/upgrade starts, normal operations on this unit cannot be performed until updating/
upgrading is completed. Furthermore, there may be cases where backup data is reset for the
parameters, etc., set on this unit.
• If the update or upgrade fails, press and hold the
remove and re-insert the power cord. "Update retry" appears on the display and update restarts from
the point at which update failed. If the error continues despite this, check the network environment.
• Information regarding the "Update" function and "Add New Feature" will be announced on the DENON
web site each time related plans are defined.
• When usable new firmware is released with "Update" or "Add New Feature", a notification message
is displayed on the menu screen. When you do not want to be notified, set "Notifications" – "Update"
(vpage 132) and "Notifications" – "Upgrade" (vpage 132) to "Off".
DVD
Setting details
STATUS
and for at least 3 seconds.
X
on the main unit for more than 5 seconds, or
Setup Lock
Protect settings from inadvertent change.
Setting items
On : Turn protection on.
Lock
Off : Turn protection off.
When canceling the setting, set "Lock" to "Off".
NOTE
When "Lock" is set to "On", the settings listed below can no longer be
changed. Also, "Setup Locked!" is displayed if you attempt to operate
related settings.
• Setup menu operations
133
General
Default settings are underlined.
Setting details