Denon AVR-2313CI Owner's Manual page 125

Setting items
Distances Unit : Set the unit of distance.
Set distance from listening • Feet / Meters
position to speakers.
Step : Set the minimum variable width of the distance.
Measure beforehand the
• 1ft / 0.1ft
distance from the listening
• 0.1m / 0.01m
position to each speaker.
Set Defaults : The "Distances" settings are returned to the default
settings.
• Yes : Reset to the defaults.
• No : Do not reset to the defaults.
When you select "Set Defaults" and press
ENTER
, the "Reset to the default values?"
prompt is displayed. Select either "Yes" or
"No", and press
Front L / Front R / F. Height L / F. Height R / Center / Subwoofer /
Surround L / Surround R / Surr. Back L
Front Wide R : Select speaker for distance setting.
z When the "Speaker Config." – "Surr. Back" setting (vpage 121) is
set to "1spkr", "Surr. Back" is displayed.
• 0.0ft – 60.0ft / 0.00m – 18.00m : Set the distance.
• The speakers that can be selected differ depending on the "Amp Assign"
(vpage 120) and "Speaker Config." (vpage 120) settings.
• Default settings :
Front L / Front R / F. Height L / F. Height R / Center / Subwoofer / Front
Wide L / Front Wide R : 12.0 ft (3.60 m)
Surround L / Surround R / Surr. Back L / Surr. Back R : 10.0 ft (3.00 m)
• Set the difference in the distance between the speakers to less than
20.0 ft (6.00 m).
NOTE
Speakers set to "None" in "Speaker Config."
displayed.
DVD
Setting details
ENTER
.
z z
/ Surr. Back R / Front Wide L /
(vpage 120) are not
Setting items
Levels Test Tone Start : Output test tone.
Set the volume of the test • Front L / F. Height L / Center / F. Height R / Front R / Front Wide R /
tone to be the same when it Surround R / Surr. Back R
is output from each speaker. Front Wide L / Subwoofer : Select speaker to output test tone.
z When the "Speaker Config." – "Surr. Back" setting (vpage 121) is
set to "1spkr", "Surr. Back" is displayed.
• –12.0dB – +12.0dB (0.0dB) : Adjust the volume.
When "Levels" is adjusted, the adjusted values are set for all the sound
modes.
NOTE
• Speakers set to "None" in the "Speaker Config."
settings are not displayed.
• When a headphones jack is inserted in the PHONES jack of this unit, the
"Levels" is not displayed.
Set Defaults : The "Levels" settings are returned to the default settings.
• Yes : Reset to the defaults.
• No : Do not reset to the defaults.
When you select "Set Defaults" and press
ENTER
prompt is displayed. Select either "Yes" or
"No", and press
122
Setting details
z z
/ Surr. Back L
, the "Reset to the default values?"
ENTER
.
v See overleaf
Speakers
/ Surround L /
(vpage 120)