Denon AVR-2313CI Owner's Manual page 124

Setting items
Speaker Config. Surr. Back : Set the presence, size and number of surround back speakers.
(Continued) • Large : Use a large speaker that can adequately play back low
frequencies.
• Small : Use a small speaker that has inadequate playback capacity for
low frequencies.
• None : Select when the surround back speakers are not connected.
• 2spkrs : Use two surround back speakers.
• 1spkr : Use only one surround back speaker. When you select this
setting, connect the surround back speaker to the left (L) channel.
NOTE
When "Assign Mode" setting
can make the "Surr. Back" setting.
Front Height : Set the presence and size of the front height speakers.
• Large : Use a large speaker that can adequately play back low
frequencies.
• Small : Use a small speaker that has inadequate playback capacity for
low frequencies.
• None : Select when the front height speakers are not connected.
NOTE
When "Assign Mode" setting (vpage 120) is "Front Height", you can
make the "Front Height" setting.
Front Wide : Set the presence and size of the front wide speakers.
• Large : Use a large speaker that can adequately play back low
frequencies.
• Small : Use a small speaker that has inadequate playback capacity for
low frequencies.
• None : Select when the front height speakers are not connected.
NOTE
When "Assign Mode" setting
make the "Front Wide" setting.
DVD
Setting details
(vpage 120) is "Surround Back", you
(vpage 120) is "Front Wide", you can
121
Setting items
Bass Subwoofer Mode : Select low range signals to be reproduced by
Set subwoofer and LFE subwoofer.
signal range playback. • LFE : The low range signal of the channel set to "Small" speaker size is
added to the LFE signal output from the subwoofer.
• LFE+Main : The low range signal of all channels is added to the LFE
signal output from the subwoofer.
• "Subwoofer Mode" can be set when "Speaker Config." – "Subwoofer"
(vpage 120) is set to "Yes".
• Play music or a movie source and select the mode offering the strongest
bass.
• Select "LFE+Main" if you want the bass signals to always be produced
from the subwoofer.
NOTE
If "Front" and "Center" for "Speaker Config." are set to "Large", and
"Subwoofer Mode" is set to "LFE", no sound may be output from the
subwoofers, depending on the input signal or selected sound mode.
LPF for LFE : Set LFE signal playback range. Set this when you want to
change the playback frequency of the subwoofer.
• 80Hz / 90Hz / 100Hz / 110Hz / 120Hz / 150Hz / 200Hz / 250Hz
Speakers
Setting details
v See overleaf