Denon AVR-2313CI Owner's Manual page 126

Setting items
Crossovers Crossover : Set the crossover frequency.
Set the maximum frequency • 40Hz / 60Hz / 80Hz / 90Hz / 100Hz / 110Hz / 120Hz / 150Hz / 200Hz /
of the bass signal output 250Hz / Individual : Set the crossover frequency for all speakers. See the
from each channel to speaker manual for information concerning speaker crossover frequency.
the subwoofer. Set the
The following settings can be set when the "Crossover" setting is set to
Crossover Frequency to
"Individual".
suit the bass reproduction
• Front / Center / Surround / Surr. Back / Front Height / Front Wide :
capability of the speaker
Select speaker for setting of crossover frequency.
being used.
• 40Hz / 60Hz / 80Hz / 90Hz / 100Hz / 110Hz / 120Hz / 150Hz / 200Hz /
250Hz : Set the crossover frequency.
• "Crossovers" can be set when the "Bass" – "Subwoofer Mode"
(vpage 121) setting is "LFE+Main", or when you have a speaker that
is set to "Small".
• Always set the crossover frequency to "80Hz". When using small
speakers, however, we recommend setting the crossover frequency to
a higher frequency.
• For speakers set to "Small", sound below the crossover frequency
is cut from the sound output. The cut bass sound is output from the
subwoofer or front speakers.
• The speakers that can be set when "Individual" is selected differ
depending on to the "Subwoofer Mode" setting (vpage 121).
• When "LFE" is selected, speakers set to "Small" at "Speaker Config."
can be set. If the speakers are set to "Large", "Full Band" is displayed
and the setting cannot be made.
• If set to "LFE+Main", this setting can be made regardless of the
speaker size.
2ch Playback : The front speakers used in direct play (2 channel), stereo
Front Speaker Setup
Set the front speakers to play and pure direct play (2 channel) are set in advance.
use for every sound mode. • A : Front speaker A is used.
• B : Front speaker B is used.
NOTE
• A+B : Both front speakers A and B are used.
This can be set when
Multi ch Playback : The front speakers used in play modes other than
"Assign Mode" is set to
direct play (2 channel), stereo play and pure direct play (2 channel) are set
"Front B" (vpage 120).
in advance.
• A : Front speaker A is used.
• B : Front speaker B is used.
• A+B : Both front speakers A and B are used.
DVD
Speakers
Setting details
123