North Star DIMENSION Service Manual page 24

SYSTEM HARDWARE INSTALLATION
Central Module (cont.)
Procedure : Central Module Installation and Configuration
14. Notice that each
workstation circuit
board has a connec-
tor which projects
through the rear
panel of the central
module.
Uncoil the work-
station cables and
attach one cable to
each of the connec-
tors. Fasten the
cables securely,
using the screws
attached to the
cable plugs.
workstation
circuit board
connector
15. Replace the top cover of the central module , and fasten it
with the three screws which you removed in step #1.
16. Notice the selectable power line receptacle located on the
rear panel of the central module. It consists of a voltage
selection cam, a fuse and fuse holder and a receptacle for
the main power cord. ( See the illustrations in steps #18 and
#19.)
If the power outlets in your office supply the voltage shown
in the window of the power receptacle , proceed to step #21.
If the power outlets in your office do not supply the
voltage shown, proceed to step #17.
1-12 Technical Manual