Diskette Drive - North Star DIMENSION Service Manual

SUBASSEMBLY REMOVAL
Diskette Drive
Introduction
Use the following procedure to remove the diskette drive
from the central module.
In order to remove the diskette drive, first remove the
drive mount bracket in which the drive is mounted.
Procedure: Diskette Drive Removal
1. Loosen the four Phillips screws that fasten the drive mount bracket to
the base panel of the central module.
2. Remove the screws that fasten the drive mount bracket to the
front panel.
3. Disconnect the DC power and signal harnesses from the rear edges of
the tape and diskette drives.
Note: If there are spare DC power harnesses tie-wrapped to the
bracket, cut the tie wrap.
4. Slide the drive mount bracket toward the rear of the central module,
and lift the bracket straight out of the central module.
5. Bow the front panel mask and remove it from beneath the diskette
drive bezel (and tape drive bezel, if one is installed).
6. Remove the four Phillips screws that fasten the diskette drive to the
drive mount bracket.
IWO
4-14 DIMENSION Service Manual