North Star DIMENSION Service Manual page 225

SUBASSEMBLY REMOVAL
Bus PCB
Introduction
Use this procedure to remove the bus PCB from the
central module.
Procedure :
Bus PCB Removal
1. Remove all workstation PCB's from the central module.
2. Loosen the five
Phillips screws
which fasten the
two red +5VDC leads
and the three black
ground leads to the
front edge of the
bus PCB.
3. Disconnect the +5VDC
and ground leads
from the bus PCB.
4. Unplug the yellow
+12VDC lead from the
right edge of the
bus PCB.
9
P
R
VLU
Technical Manual 6-11