North Star DIMENSION Service Manual page 177

SUBASSEMBLY REMOVAL
OMNINET Board
Introduction Use this procedure for removing an OMNINET board from
the central module.
Procedure: OMNINET Board Removal
1. Disconnect the 3-pin female connector ( attached to the white
OMNINET cable) from the OMNINET circuit board in the central
module.
2. Remove the Phillips head screw that fastens the rear edge of the
OMNINET board to the rear panel of the central module.
3. Lift the OMNINET board straight up and out of the central module.
This concludes the procedure for removing the OMNINET board.
DIMENSION Service Manual 4-5