Configure Vlan Mac Addresses And Lan Advanced Settings - NETGEAR SRX5308 Reference Manual

Note: Once you have completed the LAN setup, all outbound traffic is
allowed and all inbound traffic is discarded except responses to
requests from the LAN side. For information about how to change
these default traffic rules, see
Note: For information about the DHCP log, see
page 290.

To edit a VLAN profile:
1. On the LAN Setup screen (see
column for the VLAN profile that you want to modify. The Edit VLAN Profile screen
displays. This screen is identical to the Add VLAN Profile screen.
2. Modify the settings as explained in the previous table.
3. Click Apply to save your settings.

To enable, disable, or delete one or more VLAN profiles:
1. On the LAN Setup screen (see
the VLAN profile that you want to delete, or click the Select All table button to select all
profiles. (You cannot select the default VLAN profile.)
2. Click one of the following table buttons:
• Enable. Enables the VLAN or VLANs. The ! status icon changes from a gray circle to
a green circle, indicating that the selected VLAN or VLANs are enabled. (By default,
when a VLAN is added to the table, it is automatically enabled.)
• Disable. Disables the VLAN or VLANs. The ! status icon changes from a green circle
to a gray circle, indicating that the selected VLAN or VLANs are disabled.
• Delete. Deletes the VLAN or VLANs.

Configure VLAN MAC Addresses and LAN Advanced Settings

By default, all configured VLAN profiles share the same single MAC address as the LAN
ports. (All LAN ports share the same MAC address). However, you can change the VLAN
MAC settings to allow up to 16 VLANs to each be assigned a unique MAC address.
You can also enable or disable the broadcast of Address Resolution Protocol (ARP) packets
for the default VLAN. If the broadcast of ARP packets is enabled, IP addresses can be
mapped to physical addresses (that is, MAC addresses).
For information about the LAN traffic meter, see
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Figure 30
Figure 30
LAN Configuration
Chapter 4, Firewall Protection.
View the DHCP Log
on page 59), click the Edit button in the Action
on page 59), select the check box to the left of
Enable the LAN Traffic Meter
64
on
on page 268.