NETGEAR SRX5308 Reference Manual page 15

ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
The front panel also contains three groups of status indicator light-emitting diodes (LEDs),
including Power and Test LEDs, LAN LEDs, and WAN LEDs, all of which are explained in the
following table.
Left LAN LEDs
Power LED
Right LAN LEDs
Test LED
Figure 1.
Table 1. LED descriptions
LED Activity
Power On (green)
Off
Test On (amber) during
startup.
On (amber) during
any other time
Blinking (amber)
Off
LAN Ports
Left LED On (green)
Blinking (green)
Off
Right LED On (green)
On (amber)
Off
DMZ LED
Left WAN LEDs
Right WAN LEDs
Description
Power is supplied to the VPN firewall.
Power is not supplied to the VPN firewall.
Test mode: The VPN firewall is initializing. After approximately
2 minutes, when the VPN firewall has completed its initialization, the
Test LED goes off.
The initialization has failed, or a hardware failure has occurred.
The VPN firewall is writing to flash memory (during upgrading or
resetting to defaults).
The system has booted successfully.
The LAN port has detected a link with a connected Ethernet device.
Data is being transmitted or received by the LAN port.
The LAN port has no link.
The LAN port is operating at 1000 Mbps.
The LAN port is operating at 100 Mbps.
The LAN port is operating at 10 Mbps.
Introduction
15
Internet
LEDs