NETGEAR SRX5308 Reference Manual page 275

Table 67. Firewall Logs & E-mail screen settings (continued)
Setting
Enable SysLogs
Enable
3. Click Apply to save your settings.
Note: Enabling logs might generate a significant volume of log messages.
NETGEAR recommends that you enable firewall logs for debugging
purposes only.

To view the routing logs, system logs, and other event logs onscreen:
1. Select Monitoring > Firewall Logs & E-mail. The Firewall Logs & E-mail screen
displays.
2. Click the View Log option arrow in the upper right of the Firewall Logs & E-mail screen.
The View Log screen displays:
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Description
Select one of the following radio buttons to configure the syslog server:
Yes. The VPN firewall sends a log file to a syslog server. Complete the SysLog
Server and SysLog Severity fields that are shown on the right side of the screen (see
explanations later in this table).
• No. The VPN firewall does not send a log file to a syslog server, which is the
default setting.
SysLog Server The IP address or name of the syslog server.
SysLog All the logs with a severity that is equal to and above the severity
Severity that you specify are logged on the specified syslog server. For
example, if you select LOG_CRITICAL as the severity, then the logs
with the severities LOG_CRITICAL, LOG_ALERT, and
LOG_EMERG are logged.
From the SysLog Severity drop-down list, select one of the following
syslog severities:
• LOG EMERG. The VPN firewall is unusable.
• LOG ALERT. An action needs to be taken immediately.
• LOG CRITICAL. There are critical conditions.
• LOG ERROR. There are error conditions.
• LOG WARNING. There are warning conditions.
• LOG NOTICE. There are normal but significant conditions.
• LOG INFO. Informational messages.
• LOG DEBUG. Debug-level messages.
Monitoring System Access and Performance
275