NETGEAR SRX5308 Reference Manual page 38

then a new FTP session could start on the WAN2 interface, and then any new
connection to the Internet could be made on the WAN3 interface. This
load-balancing method ensures that a single WAN interface does not carry a
disproportionate distribution of sessions.
3. Click Apply to save your settings.
Configure Protocol Binding (Optional)

To configure protocol binding and add protocol binding rules:
1. Select Network Configuration > Protocol Binding.
2. Select the Load Balancing radio button. The Protocol Bindings screen displays. (The
following figure shows two examples in the Protocol Bindings table.)
Figure 20.
The Protocol Bindings table displays the following fields:
• Check box. Allows you to select the protocol binding rule in the table.
• Status icon. Indicates the status of the protocol binding rule:
- Green circle. The protocol binding rule is enabled.
- Gray circle. The protocol binding rule is disabled.
• Service. The service or protocol for which the protocol binding rule is set up.
• Local Gateway. The WAN interface to which the service or protocol is bound.
• Source Network. The computers or groups on your network that are affected by the
protocol binding rule.
• Destination Network. The Internet locations (based on their IP address) or groups
that are covered by the protocol binding rule.
• Action. The Edit table button, which provides access to the Edit Protocol Binding
screen for the corresponding service.
3. Click the Add table button below the Protocol Binding table. The Add Protocol Binding
screen displays:
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Connecting the VPN Firewall to the Internet
38