NETGEAR SRX5308 Reference Manual page 191

Table 47. VPN client IPSec configuration settings (Mode Config) (continued)
Setting
ESP
PFS and Group
4. Click Apply to use the new settings immediately, and click Save to keep the settings for
future use.
Configure the Mode Config Global Parameters

To specify the global parameters:
1. Click Global Parameters in the left column
Global Parameters pane displays in the
Figure 117.
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Description
Encryption Select 3DES as the encryption algorithm from the drop-down list.
Authentication Select SHA-1 as the authentication algorithm from the drop-down
list.
Mode Select Tunnel as the encapsulation mode from the drop-down list.
Select the PFS check box, and then select the DH2 (1024) key group from the
drop-down list.
Note: On the VPN firewall, this key group is referred to as Diffie-Hellman Group 2
(1024 bit).
Virtual Private Networking Using IPSec Connections
of the Configuration Panel screen.
Configuration Panel screen.
191
The