Connections - Panasonic OmniVision PV-DF2035-K Operating Instructions Manual

Connections

Notes on con nec tions
• Turn off the power supply for all com po nents before making any connections.
• If the cables necessary for connecting a component to the system are not included with the component or available as an option, you may need to
fashion a cable to suit the component concerned.
• Read the instruction manual for each system component care ful ly before connecting it.
Connecting the RF in Terminal
CAUTION
Overtightening "Nut type" RF coaxial cables may damage
jacks. Finger tighten only.
Antenna Connection
Connect the cable from the Antenna to the VHF/UHF terminal
on the unit.
VHF
Antenna
Mixer
Cable Connection
Connect the cable supplied by your local cable company
to the VHF/UHF terminal on the unit.
Cable Box
In from CABLE
Note to CABLE system installer:
This re mind er is pro vid ed to call the CABLE (Cable TV) System
Installer's at ten tion to Article 820-40 of the NEC that pro vides
guide lines for proper grounding and, in par tic u lar, specifies that
the cable ground shall be con nect ed to the ground ing system of
the build ing, as close to the point of cable entry as practical.
10
UHF
Antenna
Or
Connecting the "1, 2" AV Input Terminals
Connects VCRs and other peripheral equipment
AV Input terminal 1 is used
Notes:
• Similar connections are available at the "1, 2" AV input terminals.
• AV Input terminal 2 is located on the front of the unit.