Connections/Initial Setup (Ready To Play) - Panasonic OmniVision PV-C2023-K Operating Instructions Manual

Connections/Initial Setup
Please make all cable or antenna connections before power on.
Connecting
For ANT./Cable
Connect the cable from Antenna/Cable
to the VHF/UHF terminal on the unit.
UNIT (rear view)
VHF/UHF
VHF/UHF
WARNING:
Overtightening "Nut type" RF coaxial cables may damage jacks. Finger tighten only.
Initial Setup (Ready to Play)
Press COMBO on the remote for Combo mode.
Plug the unit power cord into AC wall
1
outlet.
Press POWER on the remote or unit.
2
Auto channel and clock set starts.
3
CH AUTO SET PROCEEDING
AUTO CLOCK SET
PROCEEDING
CANCEL : STOP
8 8
For DSS/Cable Box
Connect the OUT jack on your cable
box to the VHF/UHF terminal on the unit
with a RF cable.
IN from
ANT./CABLE
4
Press CH to
select English.
OR
Press CH to
select French
(Français).
OR
Press VOL+ to
select Spanish
(Español).
• If you use a cable
box, turn it on and
• Function buttons are inoperative during Initial
set it to the Public
Broadcasting Service
• To remove a cassette during Auto Set, press
(PBS) channel in your
time zone. If you use
a DSS receiver, it
must be turned off.
• Depending on conditions, Auto Clock Set may
(Ready to Play)
UNIT (rear view)
Cable TV
Converter Box
VHF/UHF
VHF/UHF
Settings are made automatically. When
setup is done, this screen appears.
2 / 6 / 2003 THU 12 : 00PM
DST : ON
SETT I NG : CH 1 0
AUTO CLOCK SET
COMPLETED
If AUTO
CLOCK SET IS
INCOMPLETE
screen appears,
set the clock using
MANUAL CLOCK
SET procedure on
PLEASE SET CLOCK BY
PRESSING ACTION KEY
next page.
Notes
Setup.
EJECT twice on the remote or STOP twice on
the unit. In this case, settings must be made
manually. (See page 10.)
take longer than 30 minutes. If so, press STOP
to stop setup and perform settings manually.
(See page 10.)
IN from
ANT./CABLE
AUTO CLOCK SET
IS INCOMPLETE