Replacing The Heat Sink And Processor - Gateway Desktops User Manual

CHAPTER 13: Adding and Replacing Components

Replacing the heat sink and processor

Tips & Tricks
You need a Phillips screwdriver to replace
the heat sink.
150
Slide the power supply away from the back of the computer, then pull it
5
down and remove it.
Install the new power supply into the case, then install the three screws
6
to secure the power supply to the case.
Reconnect the power supply cables using your notes from
7
Replace the side panel by following the instructions in
8
panel" on page 140.
To replace the heat sink and processor:
Remove the side panel by following the instructions in
1
panel" on page 138.
For more stability, place your computer on its side. To avoid scratching the
2
case, place it on a towel or other non-abrasive surface.
Remove the fan by pulling it away from the system board.
3
www.gateway.com
Step 3.
"Replacing the side
"Removing the side