Replacing The Heat Sink And Processor - Gateway GT5448E - GT - 2 GB RAM Reference Manual

3
4
5
6
7
Replacing the heat sink and
processor
To replace the heat sink and processor:
1
48
CHAPTER 4: Upgrading Your Computer
Remove the three screws that secure the power supply
to your computer.
Slide the power supply away from the back of your
computer, then pull it down and remove it.
Install the new power supply into the case, then install
the three screws to secure the power supply to the case.
Reconnect the power supply cables using your notes
from Step 2.
Replace the side panel by following the instructions in
"Replacing the side panel" on page
Tools
You need a Phillips screwdriver to replace the heat sink.
Remove the side panel by following the instructions in
"Removing the side panel" on page
Screws
33.
31.