Replacing The I/O Board - Gateway Desktops User Manual

CHAPTER 13: Adding and Replacing Components

Replacing the I/O board

Important
The color and shape of your replacement
component's front cover may vary from
your original component.
152
Remove the processor from the system board.
7
Install the new processor onto the system board making sure that Pin 1
8
on the processor (indicated by the silk-screened arrow on the corner of
the processor) aligns with Pin 1 on the processor socket (indicated by the
absence of a pin hole in the processor socket), then return the lever to its
locked position.
Place the heat sink on the system board, then tighten the screws that
9
secure it to the system board.
Connect the fan cable to the system board, then insert the fan into place.
10
Replace the side panel by following the instructions in
11
panel" on page 140.
To replace the front I/O panel:
Remove the side panel by following the instructions in
1
panel" on page 138.
Remove the bezel by following the instructions in
2
bezel" on page 139.
Disconnect the cable from the I/O panel.
3
Remove the screw that secures the I/O panel to the computer, then
4
remove the I/O panel from the computer.
Insert the new I/O panel board into the computer, then replace the screw.
5
www.gateway.com
"Replacing the side
"Removing the side
"Removing the front
Screw