Adding Or Replacing An Expansion Card - Gateway Desktops User Manual

www.gateway.com

Adding or replacing an expansion card

Connect the I/O panel cable to the new I/O panel.
6
Replace the front bezel by following the instructions in
7
front bezel" on page
Replace the side panel by following the instructions in
8
panel" on page 140.
To add or replace an expansion card:
Remove the side panel by following the instructions in
1
panel" on page 138.
For more stability, place your computer on its side. To avoid scratching the
2
case, place it on a towel or other non-abrasive surface.
If you are adding a new expansion card, go to the next step. If you are
3
replacing an expansion card, go to
Disconnect any cables that are attached to the card, noting their locations
4
and orientation. (You may need to reconnect the cables after you install
the new card.)
Open the card retention lever.
5
Adding or replacing an expansion card
140.
Step 7.
"Replacing the
"Replacing the side
"Removing the side
153