Replacing The Heat Sink And Processor - Gateway GT5042j Hardware Reference Manual

www.gateway.com
Important
Your computer hardware options and
port locations may vary from this

Replacing the heat sink and processor

Tips & Tricks
You need a Phillips screwdriver to replace
the heat sink.
Remove the three screws that secure the power supply to the computer.
3
illustration.
Slide the power supply away from the back of the computer, then lift up.
4
Install the new power supply into the case, then install the three screws
5
to secure the power supply to the case.
Reconnect the power supply cables using your notes from
6
Replace the side panel by following the instructions in
7
panel" on page
To replace the heat sink and processor:
Remove the side panel by following the instructions in
1
panel" on page
For more stability, place your computer on its side. To avoid scratching the
2
case, place it on a towel or other non-abrasive surface.
15.
12.
Replacing the heat sink and processor
Screws
Step
"Replacing the side
"Removing the side
2.
27