Replacing The Heat Sink And Processor - Gateway GM5416 Reference Manual

9
10
11
12
13
14
15
Replacing the heat sink and
processor
To replace the heat sink and processor:
1
2
3
www.gateway.com
Line up the tabs on the right side of the cage with the
slots on the inside of the case, then slide the cage into
the case.
Hard drive cage tabs
Tighten the cage thumbscrew, then plug the hard drive
cage fan cable back into the system board.
Connect the drive cables. If you are replacing a drive,
use your notes from
Replace the side panel by following the instructions in
"Replacing the side panel" on page
Reconnect all external cables and the power cord.
Turn on your computer.
If you are using the new hard drive as your primary
drive, install Windows using the operating system DVD
that came with your computer. For more information on
restoring your system, see
on page 91.
Tools
You need a Phillips screwdriver to replace the heat sink.
Remove the side panel by following the instructions in
"Removing the side panel" on page
For more stability, place your computer on its side. To
avoid scratching the case, place it on a towel or other
non-abrasive surface.
Unplug the heat sink fan cable from the system board.
Slots on inside of case
Step 2.
34.
"Recovering your system"
31.
45