Table of Contents
Advertisement
Communication Setup Menu
The Communication setup menu is used to
set up communications.
Note
The contents of the Communication menu vary
with the "Line Interface" setting in the Line I/F
setup menu.
Depending on the item, the settings can be
configured individually for transmission and
reception, and point-to-point connection and
multipoint connection.
The Communication page number after the
Communication2 page also varies according to
the number of setting items.
Communication
IP
The menu is used to set up the
communication mode for the IP connection.
Individual Settings for Transmission/
Reception
Allows you to configure the IP settings for
transmission and reception individually.
Individual Settings for Point-to-Point/
Multipoint (only with PCSA-MCG80
installed)
Allows you to configure the IP settings for a
point-to-point connection and multipoint
connection individually.
Communication
IP: Mode
Total Bandwidth (only with
PCSA-MCG80 installed)
Allows you to select the total bandwidth to
be used with this system.
In multipoint connection, the total
bandwidth of all points is displayed.
You can select from among 128Kbps,
384Kbps, 512Kbps, 1Mbps, 2Mbps, 3Mbps,
4Mbps, and Other.
Note
In multipoint connection, the actual
Communication Bit Rate for each point is
automatically adjusted so as not to exceed
"Total Bandwidth".
Communication Bit Rate
Allows you to select the communication bit
rate per point.
You can set this item for transmission and
reception, and point-to-point and multipoint
connections individually.
You can select from among 128Kbps,
384Kbps, 512Kbps, 1Mbps, 2Mbps, 3Mbps,
4Mbps, and Other.
Audio Mode
Allows you to select the compression format
of audio to be sent to a remote party. You
can set this item for transmission and
reception, and point-to-point and multipoint
connections individually.
You can select multiple formats from among
G.711, G.722, G.728 and MPEG4 (MPEG4
AAC).
Notes
• When configuring multipoint connection
settings, you can only select from G.711 or
G.722.
• When the remote system does not support the
audio mode selected by the local site, the
mode automatically becomes "G.711".
Far End Camera Control
Allows you to select whether to enable the
control of each other's cameras from each
other's site.
You can set this item for point-to-point and
multipoint connections individually.
On: Enables the control of each other's
cameras. Normally, set to "On".
Off: Disables the control of each other's
cameras.
H.239
Use of the presentation mode complying
with H.239 allows you to transmit the
presentation data and picture from the
camera simultaneously.
This item allows you to select whether to use
the presentation mode based on the H.239
presentation standard.
On: Enables the presentation mode based on
the H.239 presentation standard.
Off: Disables the presentation mode based
on the H.239 presentation standard.
Registering Local Information
61
Advertisement
Table of Contents
