Table of Contents
Advertisement
Installation Preparation
Preparing the Water Connection (A)
• Install an easily accessible shut-off valve
(not supplied) in the water supply line. All
solder connections must be made before
the water line is connected to the
dishwasher's water inlet valve. Water can
also be supplied to the dishwasher by
using a flexible braided hose line.
WARNING
Installation should be performed by a
qualified installer. Work by unqualified
persons could be dangerous and may
void the warranty.
If the dishwasher is installed in a
location that experiences freezing
temperatures (e.g. in a vacation home,
cabin, etc.), you must drain all the
water from the dishwasher's interior.
Water system ruptures that occur as a
result of freezing are not covered by
warranty.
Installing the 90° Elbow Fitting (B)
B
• Check with your plumbing supply sources
for the proper hose and 90° elbow and
necessary fittings for the water supply line.
This material is not supplied and must be
purchased separately.
Do not overtighten the 90° elbow.
Doing so may damage the water inlet
valve and cause a water leak.
If the water supply line is to be copper
tubing, make certain that the elbow has a
compression fitting. Apply Teflon tape or
other pipe sealant when required. Orient the
A
water supply connection downwards as
shown in the figure so the water line can be
easily pulled underneath or on the side of
the dishwasher.
11
CAUTION
Advertisement
Table of Contents
