Denon AVR-X1100W Service Manual page 48

3.7. TUNER STEP mode (for E2 / E3)
3.3.1. Actions
This is a special mode for enabling reception STEP of the ANALOG TUNER to be changed.
3.7.2. Starting up
AVR-X1100W
・ Hold down buttons "ZONE2 SOURCE", "DIMMER" and "STATUS" at the same time and press the power button to turn
on the power.
AVR-S700W
・ Hold down buttons "TUNER PRESET CH+", "TUNE -" and "PRESET +" at the same time and press the power button to
turn on the power.
Select the "5. TUNER FRQ SER" using the button "TUNER PRESET CH+ / -", and press the button "STATUS" to commit
the selection.
3.7.3. Displays
Start this unit in TUNER STEP mode, select using button "TUNER PRESET CH+/-" and enter using button "STATUS".
The following information is displayed in the following order.
(a) AM9kHz/FM50kHz selected
FLD
<
"TUNER PRESET CH+"
(b) AM10KHz/FM200kHz selected
FLD
< A M 1 0 / F M 2 0 0
(C) Press the power button to turn off the power.
(D) Press the power button to turn on the power.
A M 9 / F M 5 0
"TUNER PRESET CH-"
"STATUS"
>
>
48