Precautions During Service; Initializing This Unit; Service Jigs - Denon AVR-X1100W Service Manual

PRECAUTIONS DURING SERVICE

Initializing This Unit

Initialize this unit if you have replaced the microcomputer, one of the parts around the microcomputer, or the digital PCB.
1. Press the power button to turn off the power.
2. AVR-X1100W
Hold down buttons "ZONE2 SOURCE" and "DIMMER" at the same time and press the power button to turn on the
power.
AVR-S700W
Hold down buttons TUNER PRESET CH + and "TUNE -" at the same time and press the power button to turn on the
power.
3. Release the buttons after confirming that the display flashes in intervals of approximately 1 second.
＊ The unit is initialized.
NOTE： • If the status in step 3 does not occur, start again from step 1.
• Initializing the device restores settings configured by the user to the factory settings. Take note of your settings beforehand
and reconfigure them after initialization.
AVR-X1100W
SOURCE SELECT
AVR-S700W
SOURCE SELEC

Service Jigs

The following jigs (extension cable kit) are used when repairing the PCB.
Order the jigs from your dealer if necessary.
8U- 110084S :
(See 52 page)
TUNER
PRESET CH
PHONES
X ZONE2 SOURCE
T
ZONE2 ON/OFF ZONE2 SOURCE
PHONES
MOVIE
TUNER PRESET CH +
X
EXTENSION UNIT KIT
ZONE2 ZONE2
1 2
DIMMER STATUS CBL/SAT DVD/Blu-ray
ON/OFF SOURCE
QUICK SELECT
AUX - HDMI
5V / 1A
DIMMER
TUNER
TUNE BAND MODE
PRESET CH
1 2 3 4
CB L /S AT DVD/Blu-ray GAME ONLINE
QUICK SELECT
AUX - HDMI
MUSIC GAME PURE
5V / 1A
SOUND MODE
TUNING －
: 1 Set
11
MASTER VOLUME
3 MEDIA 4
ONLINE
PLAYER
SETUP MIC
MASTER VOLUM E
DIMMER STATUS
SETUP MIC