Table of Contents
Advertisement
Do not place the appliance near taps or sinks.
•
The appliance could be damaged if the water it contains
freezes.
Do not install the appliance in a room where the tempera-
ture could drop below freezing point.
•
Arrange the power cable in such a way that it cannot be
damaged by sharp edges or contact with hot surfaces (e.g.
electric hot plates).
Connecting the appliance
Important!
Check that the mains power supply voltage corresponds to
the value indicated on the rating plate on the bottom of the
appliance.
Connect the appliance to an efficiently earthed and correctly
installed socket with a minimum current rating of 10A only.
If the power socket does not match the plug on the appliance,
have the socket replaced with a suitable type by a qualified
professional.
Setting up the appliance
Please note!
•
Coffee has been used to factory test the appliance and it is
therefore completely normal for there to be traces of coffee
in the mill.
The machine is, however, guaranteed to be new.
•
You should customise water hardness as soon as possible
following the Instruction for use in the section "Setting
water hardness" on page 16).
1. Connect the appliance to the mains electricity supply (fig.
1) and make sure the main switch at the back of the ap-
pliance is pressed down (fig. 2).
You must first choose the language by moving backwards and
forwards with the < or > button, or waiting until the languages
scroll through on the display at intervals of about 3 seconds:
2. When "English" appears, hold the
a few seconds until "English set" is displayed.
Follow the instructions indicated on the appliance display:
3. "FILL TANK": extract the water tank (fig. 4), open the lid
(fig. 5), fill to the MAX line with fresh water (fig. 6); close
the lid again and then replace the tank.
4. "HOT WATER, Press OK": place a container with a minimum
capacity of 100ml under the cappuccino maker (fig. 7).
5. Press the
button to confirm (fig. 3). The appliance
delivers water from the spout then goes off automatically.
The coffee machine is now ready for normal use.
Please note!
•
•
TURNING THE APPLIANCE ON
Before turning the appliance on, make sure the main switch is
pressed (fig. 2).
Each time the appliance is turned on, it performs an automatic
preheat and rinse cycle which cannot be interrupted.
The appliance is ready for use only after completion of this cycle.
During rinsing, a little hot water comes out of the coffee spouts
and is collected in the drip tray underneath.
Avoid contact with splashes of water.
•
After heating, the message "RINSING" is displayed. As well as
heating the boiler, the appliance also heats the internal circuits
by circulating hot water.
The appliance is at temperature when the message indicating
the taste and quantity of coffee appears.
TURNING THE APPLIANCE OFF
Whenever the coffee machine is turned off after being used to
make coffee, it performs an automatic rinse cycle.
button (fig. 3) for
During rinsing, a little hot water flows from the coffee spouts.
Avoid contact with splashes of water.
•
•
If you will not be using the appliance for some time, unplug
from the mains socket:
•
9
When using the appliance for the first time, you need to
make 4-5 cups of coffee or 4-5 cappuccinos before it starts
to give satisfactory results.
To enjoy your coffee even more and improve the perfor-
mance of your appliance, we recommend installing a water
softener filter as described in the section " WATER SOFTE-
NER FILTER " (page 17). If your model is not provided
with a filter, you can request one from De'Longhi Customer
Services.
Please note!
Danger of burns!
To turn the appliance on, press the
The message "Heating up, Please wait" is displayed.
Danger of burns!
To turn the appliance off, press the
The message "Turning off, Please wait" is displayed: if fea-
tured, the appliance completes a rinse cycle and then goes
off (standby).
Please note!
first turn the appliance off by pressing the
(fig. 8);
button (fig. 8).
button (fig. 8).
button
Advertisement
Table of Contents
Troubleshooting
