Before Use; Checking The Appliance; Installing The Appliance; Connecting The Appliance - DeLonghi PrimaDonna Elite Experience Manual

E3. Steam spout ("choco" accessory)
E4. Choco stirrer ("choco" accessory)
E5. "Mix carafe"
E6. Funnel release slide
E7. Aero stirrer ("aero" accessory)

5. BEFORE USE

5.1 Checking the appliance

After removing the packaging, make sure the product is com-
plete and undamaged and that all accessories are present. Do
not use the appliance if it is visibly damaged. Contact De'Longhi
Customer Services.

5.2 Installing the appliance

Important!
When you install the appliance, you should respect the following
safety warnings:
• The appliance gives off heat. After positioning the appli-
ance on the worktop, leave a space of at least 3 cm between
the surfaces of the appliance and the side and rear walls
and at least 15 cm above the coffee maker.
• Water penetrating the appliance could cause damage.
• Do not place the appliance near taps or sinks.
• The appliance could be damaged if the water it contains
freezes. Do not install the appliance in a room where the
temperature could drop below freezing point.
• Arrange the power cord in such a way that it cannot be
damaged by sharp edges or contact with hot surfaces (e.g.
electric hot plates).

5.3 Connecting the appliance

Important!
Check that the mains power supply voltage corresponds to that
indicated on the rating plate on the bottom of the appliance.
Connect the appliance to a correctly installed and efficiently
earthed socket with a minimum current rating of 10A only.
If the power socket does not match the plug on the appliance,
have the socket replaced with a suitable type by a qualified
electrician.

5.4 Setting up the appliance

Please note!
• Coffee has been used to factory test the appliance and it is
therefore completely normal for there to be traces of coffee
in the mill. The machine is, however, guaranteed to be new.
• You should customise water hardness as soon as possible
following the instructions in section "20. Setting water
hardness".
1. Plug the power cord (C8) connector into the socket (A20) at
the back of the appliance and connect the appliance to the
mains electricity supply (fig. 1). Make sure the main switch
(A21) at the back of the appliance is pressed (fig. 2);
2. "SELECT LANGUAGE": press
flag corresponding to the required language appears on
the display (B), then press the flag;
Follow the instructions indicated on the appliance display:
3. "FILL TANK WITH FRESH WATER": remove the water tank
(A16) (fig. 3), open the lid (A15) (fig. 4), fill to the MAX line
(marked on the inside of the tank) with fresh water (fig. 5),
close the lid and put the tank back in the appliance (fig. 6);
8
1
(B10) or (B8) until the
3 3
5
2
4
6