Description Of Lights; Preliminary Checks; Checking The Appliance; Installing The Appliance - DeLonghi KS49 755.10 Manual

Description of lights

Light flashing: the machine is heating up or a
rinse cycle is underway�
The appliance is delivering one or two cups of
espresso coffee�
The appliance is delivering one or two cups of
long coffee�
Light on steadily: the "steam" function has
been selected;
Light flashing: you must turn the steam dial�
An alarm is displayed on the control panel (see
the section: "Explanation of lights" on page
17)�
Light on steadily: the grounds container is
missing and must be inserted in the appliance;
Light flashing: the grounds container is full and
must be emptied�
Light on steadily: the water tank is missing;
Light flashing: there is not enough water in the
tank�
Light flashing: the appliance must be descaled
(see the section "Descaling")�
Light on steadily: the appliance is performing
a descaling cycle�
ECO
ECO "Energy Saving" mode is active�

PRElImINARY ChECkS

Checking the appliance

After removing the packaging, make sure the product is
complete and undamaged and that all accessories are present�
Do not use the appliance if it is visibly damaged�
Contact De'Longhi Customer Services�

Installing the appliance

Important!
When installing the appliance, respect the following safety
warnings:
• The appliance could be damaged if the water it contains
freezes�
Do not install the appliance in a room where the
temperature could drop below freezing point�
• The appliance gives off heat.
After positioning the appliance on the worktop, leave
a space of at least 3 cm between the surfaces of the
appliance and the side and rear walls and at least 15 cm
above the coffee maker�
• Water penetrating the coffee maker could cause damage.
Do not place the appliance near taps or sinks�
• Arrange the power cable in such a way that it cannot be
damaged by sharp edges or contact with hot surfaces
(e�g� electric hot plates)�

Connecting the appliance

Important!
Check that the mains power supply voltage corresponds to
the value indicated on the rating plate on the bottom of the
appliance�
Connect the appliance to an efficiently earthed and correctly
installed socket with a minimum current rating of 10A only�
If the power socket does not match the plug on the appliance,
have the socket replaced with a suitable type by a qualified
professional�
9