Cisco TelePresence MX800 Dual Replacement Manual page 33

Cisco TelePresence MX800 Dual
Contents
Replace monitor (mounted on a stand)
Step 6: Install support handles on the monitor to be replaced
First remove the support handles from your
replacement monitor as illustrated.
Then mount the handles on the monitor you
want to replace.
This is neccessary in order to safely lift the
monitor.
D15327.01 MX800 Dual Replacement Guide, MAY 2015.
Introduction Grilles and covers
(page 4 of 7)
Unscrew the screws (4 × M4x8,
6a
two on each handle) and remove
the two support handles from the
replacement monitor.
Mount the brackets and handles on
6c
the monitor you want to replace.
Speakers and cameras
6b
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
33
Replacement Guide
Codec and monitors Codec and monitors Appendix
Unscrew the screws (2 × M4x8, one
on each bracket) and remove the
brackets that the support handles
were fastened to.