Replace Monitor (Mounted On A Stand) - Cisco TelePresence MX800 Dual Replacement Manual

Cisco TelePresence MX800 Dual
Contents

Replace monitor (mounted on a stand)

The illustrations provided show how to replace the right monitor. The same steps
should be taken on the left monitor, when replacing the left monitor.
Step 1: Remove speaker grille, lower grille, loudspeakers and camera
Follow the steps described in "Replace dual camera module"
22.
Note that you have to remove all loudspeakers that are mounted on the
monitor that you are replacing.
Step 2 (left monitor): Remove codec
Follow the steps described in "Replace codec"
Step 2 (right monitor): Remove PoE injector
Follow the steps described in "Replace PoE injector"
Step 3: Remove center covers
Follow the steps described in "Replace center top profile, camera cover and center
back cover" on page 11 to page 12.
Spare parts:
• Left monitor: CTS-MX800-MON-L-D=
• Right monitor: CTS-MX800-MON-R-D=
D15327.01 MX800 Dual Replacement Guide, MAY 2015.
Introduction Grilles and covers
(page 1 of 7)
on page 16 to page
on page 24 to page 27.
on page 28 to page 29.
Speakers and cameras
4
90 kg / 200 lb
The monitor is heavy. We recommend
four people working together to replace
the monitor.
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
30
Replacement Guide
Codec and monitors Codec and monitors Appendix