D15327.01 Mx800 Dual Replacement Guide, May - Cisco TelePresence MX800 Dual Replacement Manual

Cisco TelePresence MX800 Dual
Contents
Replace dual camera module
Step 2: Remove loudspeakers from positions 4, 5 and 6 above
left monitor and positions 2 and 3 above right monitor
This procedure is shown for loudspeaker 5 above the left monitor. Repeat
the procedure for loudspeaker 4 and 6 above the left monitor, and 2 and 3
above the right monitor.
When reconnecting a loudspeaker, make sure to connect the
correct cable. The cables are marked with the loudspeaker's
position. Loudspeaker cable 1 above the right monitor is not used.
Remove screw.
2a
PT4x10, Torx T20

D15327.01 MX800 Dual Replacement Guide, MAY 2015.

Introduction Grilles and covers
(page 2 of 7)
Pull loudspeaker 10-15 cm (4-6 inch) out.
2b
Speakers and cameras Speakers and cameras
1
Loudspeaker
2
positions
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
17
Replacement Guide
Codec and monitors Appendix
3
4
5
6
2
3
Unplug the cable from the connector on
2c
the back of the loudspeaker.
4
5
6