Re-Assembly - Cisco TelePresence MX800 Dual Replacement Manual

Cisco TelePresence MX800 Dual
Contents
Replace codec
(page 4 of 4)
Step 4: Pull out codec using velcro strap at top
The codec is mounted in a
power dock. Pull firmly to get
it out.

Re-assembly:

In order to install the new codec,
follow all the steps in reverse order.
D15327.01 MX800 Dual Replacement Guide, MAY 2015.
Introduction Grilles and covers Speakers and cameras
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
27
Replacement Guide
Codec and monitors Codec and monitors Appendix