Step 2: Remove The Loudspeaker - Cisco TelePresence MX800 Dual Replacement Manual

Cisco TelePresence MX800 Dual
Contents
Replace a loudspeaker

Step 2: Remove the loudspeaker

The same procedure applies for loudspeakers in all positions.
Remove screw.
2a
PT4x10, Torx T20
Re-assembly:
In order to install the new loudspeaker, follow the steps in reversed order.
D15327.01 MX800 Dual Replacement Guide, MAY 2015.
Introduction Grilles and covers
(page 2 of 2)
Pull loudspeaker 10-15 cm (4-6 inch) out.
2b
Speakers and cameras Speakers and cameras
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
15
Replacement Guide
Codec and monitors Appendix
Unplug the cable from the connector on
2c
the back of the loudspeaker.