Assembly; Installing Handwheels; Assembling Leg Stand - RIDGID TS2412 Owner's Manual

Assembly

Installing Handwheels

1. From the bag labeled "Miscellaneous" remove only the
following hardware:
2 Pan Head Screws, 10 - 32 x 5/8" long
2 Lockwashers, #10 External Type
From the large parts bag find the following:
2 Handwheels
2. Line up flat spots on shaft and handwheel, push
handwheel onto shaft. Install screw and lockwasher to
fasten handwheel to shaft. Repeat for the other hand-
wheel.

Assembling Leg Stand

1. Locate the carton containing the leg stand.
Remove all parts from packing material.
2. From the bag labeled "Legs" remove the following
hardware:
24 Truss Head Screws, 1/4-20 x 1/2" long
24 Lockwashers, 1/4" External Type
24 Hex Nuts, 1/4-20
8 Hex Nuts, 3/8-16
4 Leveling Feet
From the leg stand carton find the following:
4 Legs
2 End Stringers
2 Side Stringers
4 Leg Braces (Two Short, Two Long)
3. Assemble the legs as shown.
Insert the truss head screws through the holes in the
legs, then through the holes in the side and end string-
ers.
Legs must be assembled on top of stringers
4. Install the lockwashers. Screw on the nuts hand tight.
5. Insert the truss head screws through the holes in the
legs, then through the holes in the leg braces.
6. Install the lockwashers. Screw on the nuts but do not
tighten until completely assembled.
7. Install leveling feet through holes in bottom of legs as
shown.
8. Once you have completed the entire assembly pro-
cess, move saw to desired location and adjust the lev-
eling feet as follows:
a. With 9/16" wrench loosen bottom nut.
b. Back off top nut by hand.
c. Raise or lower foot by adjusting bottom nut using 9/16"
wrench.
d. Snug top nut against inside of leg by hand.
e. Tighten all four bottom nuts using 9/16" wrench.
10-32 x 5/8
#10 External
Pan Head Screw
Lockwasher
Elevation
Handwheel
1/4 In. External
1/4-20 x 1/2 In.
Lockwasher
Truss Head Screw
3/8 -16 Hex Nut
Stringer
(Short)
(Long)
Leg Braces
Side Stringers
1/4-20
Hex Nut
Lockwasher
Leg Braces
(Short)
Leveling Foot
12
Handwheel
Shaft
Lockwasher
Pan Head
Bevel
Screw
Handwheel
1/4-20
Hex Nut
End
Leveling Foot
Side
Stringer
End Stringers
Legs
Truss Head
Leg Braces
(Long)
3/8-16 Hex Nuts
Leg
Screw