Assembling Universal Caster System To Saw; Locating Parts - RIDGID TS2424 Owner's Manual

Assembling Universal Caster System To Saw

Locating Parts

1. From the bag labeled "Caster" remove only the follow-
ing hardware:
8 Hex Jam Nut, 3/8-16
4 3/8 Spring Lockwasher
8 Washer, 3/8 x 7/8 x 5/64
4 Foot Leveling
WARNING: If your saw has damaged or missing
parts, they must be repaired or replaced before
this assembly can be completed. Reference your
saw owner's manual or Authorized Service Depart-
ment if necessary.
Assembly Hints:
• The swivel caster may be mounted on the left or right
side of the leg stand. See illustration.
• Make sure the leg and stiffener bolts are loose in order
to align the holes in the legs with the holes in the end
frames.
• All four connections to your leg stand are done the
same way, using the same hardware.
• It may be helpful to place the frame on blocks of wood
approximately 4" thick while assembling it to the leg
stand.
• Install frame assembly so warning label can be read
from outside the legs.
2. There are two holes in each end of the end frames.
Mount the casters through the holes which will be to
the outside of your leg stand. Use leveling feet, nuts,
lockwashers and washers as shown.
Leveling Foot
Lockwasher
Nut Hex Jam
3/8-16
Swivel Caster
Use Holes
On Outside
Washer
Nut
Leveling
18
Washer
Spring 3/8
3/8 x 7/8 x 5/64"
Nut
Lockwasher
Washer
Foot
Wood
Block