Unpacking And Checking Contents; Tools Needed; Unpacking - RIDGID TS2424 Owner's Manual

Unpacking and Checking Contents

Tools Needed

Hammer
Pliers
Phillips Screwdriver
Medium Screwdriver
Small Screwdriver
Combination Wrenches
7/16 In. 1/2 In. 9/16 In.
Adjustable Wrench

Unpacking

1. Separate saw and all parts from packing materials and
check each one with the illustration and the "List of
Loose Parts" to make certain all items are accounted
for, before discarding any packing material.
WARNING: If any parts are missing, do not attempt
to assemble the table saw, plug in the power cord
or turn the switch on until the missing parts are
obtained and are installed correctly.
2. Remove the protective oil that is applied to the table
top and edges of the table and table extensions. Use
any ordinary household type grease and spot remover.
WARNING: To reduce the risk of fire or health haz-
ard, never use gasoline, naptha, or similar highly
volatile solvents.
WARNING: The saw is heavy. To reduce the risk of
back injury, get help to lift the saw. Hold the saw
close to your body. Bend your knees so you can lift
with your legs, not your back.
3. Apply coat of paste wax to the table and table exten-
sions.
NOTE: Before beginning assembly:
• Check that all parts are included. If you are missing any
part, do not assemble the saw. Contact your Authorized
Service Center to get the missing part.
Hex "L" Wrenches
3/32 In., 2.5mm,
1/8 In., 5/32 In., 3/16 In.
Utility Knife
Tape Rule
C Clamp
4 x 4 Wood Block
Framing Square
• Sometimes small parts can get lost in packaging mate-
rial. Do not throw away any packaging until saw is put
together. Check packaging for missing parts before
contacting RIDGID.
• A complete parts list (Repair Parts) is at the end of the
manual. Use this list to identify the part number of the
missing part.
NOTE: At the beginning of each assembly section items
such as nuts and bolts are shown actual size.
WARNING: For your own safety, never connect
plug to power source outlet until all assembly
steps are complete, and you have read and under-
stand the safety and operating instructions.
11
Combination Square must be true. Check it's
accuracy as shown below.
Select the straight edge of
Draw light line on
3/4" thick board. This edge
board along edge
must be perfectly straight.
NOTE: The square and
straight edge are used to
align the saw. They must
be accurate if the saw is
to be aligned properly.
Should be no gap or overlap here when square
is flipped over in dotted position.
Combination
Square