RIDGID TS2424 Owner's Manual page 47

Once the trailing end is on the table:
Push Stick
When "width of rip" is 2" or wider, use the push stick to
finish the work all the way past the blade.
When "width of rip" is narrower than 2" the push stick
Auxiliary
cannot be used because the guard will interfere...use the
Fence
"C" Clamp
auxiliary fence and push block.
Attach auxiliary fence to rip fence with two "C" clamps.
Feed the workpiece by hand along the auxiliary fence
Push Block
until the end is approximately 1" past the front edge of the
table. Continue to feed using the push block.
Hold the workpiece in position and install the push block
by sliding it on top of the auxiliary fence/work support
(this may raise guard).
Workpiece
Auxiliary Fence
47