Assembling Universal Caster System; Frame Assembly - RIDGID TS2424 Owner's Manual

Assembling Universal Caster System

Frame Assembly

Locating Parts
1. From the bag labeled "Caster" remove only the follow-
ing hardware:
24 Truss Head Screws, 1/4-20 x 1/2" Long
24 Lockwashers, 1/4" External Type
24 Hex Nuts, 1/4-20
2. From the caster carton find the following:
2 End Frames Without Wheel
2 End Frames With Wheel
1 Center Frame with Actuator
1 Center Frame
Setup
1. The end frame will be assembled to the center frame
per the following instructions.
Use the holes shown with a "•" for your saw.
Assembly
1. Position the two end frames, without wheels, inside the
center frame containing the swivel caster as shown.
Align holes in end frames (shown with a "•" for your
saw type) with the holes in the center frame. Fasten
each end frame, to the center frame using six 1/4-20 x
1/2 truss head screws, lockwashers, and nuts as
shown. The bottom of each end frame should be level
with the bottom of the center frame as illustrated.
Tighten all nuts with a 7/16" wrench.
2. Position the two end frames, with fixed wheels, inside
the center frame as shown. Align holes in end frames
(shown with a "•") with the holes in the center frame.
Fasten each end frame to the center frame using six
1/4-20 x 1/2 truss head screws, lockwashers, and
nuts as shown. The bottom of each end frame should
be level with the bottom of the center frame as illus-
trated.Tighten all nuts with a 7/16" wrench.
Truss Hd. Screw
1/4-20 x 1/2"
End Frame
Without Wheel
Center Frame
Center Frame
w/Actuator
Level Bottom
With Edge
End Frames With
Level Bottom
With Edge
15
Hex Nut
Lockwasher
Ext 1/4"
End Frame
With Wheel
Wheels
1/4-20